4/11/2023 0 Comments Arduino energy monitorThe parameters are then received with a serial.print and shows on the Serial Monitor as following: Screenshot from 07-39-42 1366×768 151 KB. Here's how to build it: Step 1: Gather Components You will need: 1 x Arduino Current sensing electronics 1 x CT sensor YHDC SCT-013-000 1 x Burden resistor 18 Ohms if supply voltage is 3. ![]() The read data are processed from the sketch and then sends to the PC via Xbee module. The flow sensor should the pass on the parameters to the HM-10 Bluetooth shield Module that stacked on the arduino board. ![]() ![]() and it worked well MM-93 Features: Multi-inputs: You can measure all electrical parameters for Utility input and do the same for Renewable Source like solar or wind turbine at the same time. This potentiometer has the task to adjust the sensitivity threshold. Smart Energy Monitor based on Arduino UNO Watch on least 4 minutes you find the testing experiment on MM-93. ![]() The LED blinking causes the voltage drop down and this value is read by Arduino and compared with the voltage acquired by the potentiometer connected in the channel A0.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |